|
DESIGNED FOR THICK, NON-FLEXING MATERIAL
Creative Lift® permanent lift magnets are ideal for handling steel plates, die castings, forgings, etc. They eliminate the need for clamping devices, slings or chains. One person can perform operations previously calling for two or more people.
- Non-marring Roller Cam Release (Patent: 6,471,273)
- Less torque required to release part
- Lift capacity clearly stated on magnet
- “Jack Screw” Secondary Release
- Durable stainless steel casing
- Use only on thick, non-flexing ferrous items
- 3:1 Design Factor
- Made In The USA
- CONFORMS TO ASME B30.20 STANDARDS
| Lift Capacity* (LBS.) |
Overall Length (IN.) |
Overall Width (IN.) |
Overall Height (IN.) |
Handle (IN.) |
Weight (LBS.) |
Catalog Number |
| 400 |
5 |
2-5/8 |
6-5/8 |
5-7/8 |
7 |
CL0400 |
| 1,000 |
7-7/8 |
3-5/8 |
8-7/8 |
6-7/8 |
22 |
CL1000 |
| 1,500 |
10-3/4 |
4-7/8 |
8-7/8 |
6-3/4 |
53 |
CL1500 |
| 2,200 |
12-5/8 |
7-1/8 |
8-7/8 |
10-1/8 |
110 |
CL2200 |
| 3,000 |
16-1/2 |
9-1/4 |
18 |
16-3/4 |
325 |
CL3000 |
| *Lift CapacityValues Are Stated At 33% Of The Actual Value. See Holding Value & Maximum Sheet Length Chart Below. |
| HOLDING VALUE (LBS.) & **MAXIMUM SHEET LENGTH (Due to Sag for Material Thickness for Single Magnet Use) |
| Catalog Number |
3/16" (6' Long) |
1/4" (6' Long) |
3/8" (8' Long) |
1/2" (8' Long) |
3/4" (8' Long) |
1" (10' Long) |
| CL0400 |
400 |
400 |
400 |
400 |
400 |
400 |
| CL1000 |
600 |
900 |
1000 |
1000 |
1000 |
1000 |
| CL1500 |
800 |
1000 |
1500 |
1500 |
1500 |
1500 |
| CL2200 |
800 |
1064 |
1725 |
2000 |
2200 |
2200 |
| CL3000 |
800 |
1100 |
1800 |
2700 |
3000 |
3000 |
Note: Never stand under load being lifted. Always use extra caution. Only use lifting magnets on material that does not flex or bend. The surface of the lift, and the load being lifted, need to be clean and free of chips, oil, slag, dirt, etc. Lifting magnets must be centered on load. Not recommended for painted or finish coated surfaces. It is recommend when lifting sheets over 8', to use 2 or more lifts on a spreader bar to prevent sheet flexing, sagging or peel-off. **Maximum sheet lengths are selected due to the sag characteristics of the specified sheet. |
